OPERATING INSTRUCTIONS
TEMPERATURE CONTROL
The refrigerator control panel is located on the side
of the refrigerator compartment.
1. Light cover
2. Thermostat knob
4
LIGHT REPLACEMENT
1. Unplug the appliance .Remove the screw from
the light cover.
2. Press the hooks on the light cover.
3. Open the light cover.
4. Remove the light cover.
5. Remove the light bulb and replace with one of
not more than 15W. Reverse the steps to replace
the light cover. Wait 5 minutes before plugging
the appliance back in.
1
2
• Lower numbers indicate warmer temperature
settings.
• Higher numbers indicate colder temperature
settings.
• The recommended setting for regular daily use
is 3.
• The recommended setting for freezing fresh food
is 5.
• Actual temperature inside the appliance can
vary based on ambient operating temperature,
how often the door is opened and how much
fresh food has been recently added.
• This appliance is intended to be used in ambient
temperatures between 16 - 32°C (60 - 90°F). It
is not recommended to operate this appliance is
ambient temperatures below 10°C (50°F).
• When turning the appliance on for the fi rst time,
allow it to run empty with the door closed for a
full 24 hours before adding any fresh food.
IMPORTANT NOTE
The freezer door may be diffi cult to open
immediately after closing it. This is normal and is
due to the pressure difference between the cold
interior of the freezer and the warm air that has just
entered the freezer when the lid was opened. The
pressure will equalize within a few minutes.
If the lid is especially diffi cult to open, wait 5
minutes to allow the pressure to equalize and then
try again.
