READ ALL SAFETY INFORMATION BEFORE USING
1)
All wiring must comply with local and national
electrical codes and be installed by a qualified
electrician. If you have any questions regarding
the following instructions, contact a qualified
electrician.
2)
Check available power supply and resolve
any wiring problems BEFORE installation and
operation of this unit.
3)
This appliance draws 11.8 nameplate amps
under Cooling Mode and may be used in any
properly wired, general purpose 15 amp
household grounding receptacle
4)
For your safety and protection, this unit is
grounded through the power cord plug when
plugged into a matching wall outlet. If you are
not sure whether the wall outlets in your home
are properly grounded, please consult a
qualified electrician. DO NOT USE PLUG
ADAPTERS OR EXTENSION CORDS WITH
THIS UNIT. If it is necessary to use an
extension cord with this unit, use an approved
“air conditioner” extension cord only (available
at most local hardware stores).
5)
The manufacturer’s nameplate is located on
the rear panel of the unit and contains electrical
and other technical data specific to this unit.
6)
To avoid the possibility of personal injury,
always disconnect the power supply to the unit
before installing and/or servicing.
TABLE 1
Suggested Individual Branch Circuit
Nameplate Amps
*AWG Wire Size
11.8
14
AWG- American Wire Gauge
*Based on copper wire at 60°C temperature rating.
TABLE 2
Receptacle and Fuse Types
Rated Volts
125
Amps
15
Wall Outlet
Fuse Size
15
Time Delay Fuse
Plug Type
(or Circuit Breaker)
1
IMPORTANT SAFETY INFORMATION
ELECTRICAL
SPECIFICATIONS
CAUTION:
Do not leave this unit
unattended in a space where people or
animals cannot react to a failed unit are
located. A failed unit can cause extreme
overheating or death in such an
enclosed, unattended space.
POWER SUPPLY
CORD
The power supply cord contains a current device that senses damage to
the power cord. Do the following to test your power supply cord:
1)
Plug in the unit.
2)
The power supply cord has two buttons on the plug head. Press the TEST button; you will
hear a click as the RESET button pops-out.
3)
Press the RESET button; again you will hear a click as the button engages.
4)
The power supply cord is now supplying electricity to the unit (on somoe products this is also
indicated by a light on the plug head).
NOTE:
• Do not use this device to turn the unit on or off.
• Always make sure the RESET button is pushed in for correct operation.
• The power supply must be replaced if it fails to reset when either the TEST button is pressed,
or if the device cannot be reset.
• If the power supply cord is damaged, it cannot be repaired and must be replaced.
