Danby DAS180DBAHWDB, Owner'S Manual

Page: 9 / 92

8
Step 2: Attach Mounting Plate To Wall
The mounting plate is the device that attaches the indoor unit on the wall.
1. Remove the screw that attaches the mounting plate to the back of the indoor unit.
2. Place the mounting plate against the wall in the location where the indoor unit will be installed.
3. Drill holes for the mounting screws, ensuring that the screws enter wall studs that can support the weight
of the unit.
4. Secure the mounting plate to the wall with the provided screws. Ensure that the mounting plate is fl at
against the wall.
Note: If the wall is made of brick, concrete or similar material, drill 5 mm (0.2 in) diameter holes in the wall
and insert the provided sleeve anchors. Secure the mounting plate to the wall by tightening the screws into
the clip anchors.
Mounting Plate Dimensions
Different models have different mounting plates. To ensure
that there is ample room to mount the indoor unit, check
the diagrams below which show the two different types of
mounting plates along with the following dimensions:
• Width of mounting plate.
• Height of mounting plate.
• Width of indoor unit relative to mounting plate.
• Height of indoor unit relative to mounting plate.
• Recommended position of wall hole, both to the left and
right of the indoor unit.
• Relative distance between screw holes.
INSTALLATION INSTRUCTIONS
10.1 cm (4”)
17.9 cm (7.05”)
13.6 cm (5.35”)
3.7 cm (1.45”)
29 cm (11.4”)
4.9 cm (1.95”)
Right rear wall
hole 6.5 cm (2.5”)
Indoor unit outline
72.2 cm (28.45”)
4.9 cm (1.95”)
22.8 cm (8.98”)
22.9 cm (9.01”)
40.1 cm (15.78”)
12.6 cm (4.96”)
4.2 cm (1.65”)
29.7 cm (11.7”)
Left rear wall
hole 6.5 cm (2.5”)
Left rear wall
hole 6.5 cm (2.5in)
Right rear wall
hole 6.5 cm (2.5”)
Indoor unit outline
80.2 cm (31.6”)
5.8 cm (2.28”)
4.7 cm (1.85”)
Model B
Model A
34.8 cm (13.7”)