SAVE THESE INSTRUCTIONS!
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAFETY REQUIREMENTS
• This appliance is not intended for use by persons (including children) whose physical, sensory
or mental capabilities may be different or reduced, or who lack experience or knowledge, unless
such persons receive supervision or training to operate the appliance by a person responsible for
their safety.
• Ensure that the unit is turned off and unplugged before any changes are made to the light system.
• Keep the door closed as much as possible to ensure proper temperature and moisture levels for
your plants.
• Always unplug the power cord and disconnect the timer when not in use.
• Only use genuine spare parts from Danby or those that have been CSA, UL or CE approved.
• The LED light panel is not water proof. Do not spray water on the surface, sides or back of the
light panel.
• Do not look directly at the LED light with the naked eye as this can cause retinal damage.
• Recommended operating temperature is between 20 ~ 30 °C (68 ~ 86 °F).
• Recommended operating humidity is below 80%.
• The LED panel cannot be exposed to corrosive materials.
• The LED panel is for indoor growing only and should not be used outdoors.
• Do not touch the surface of the light system while the power is connected as it can get hot.
• Do not use the LED panel during a thunderstorm to avoid a surge that could damage the light
system.
• Do not cover shelves with aluminum foil or any other material which may prevent air circulation.
LOCATION
Select a location with a strong level fl oor that can support the weight of the unit and the plants grown
inside.
Allow 5 inches (12.7 cm) between the back of the appliance and the wall. Allow 1 inch (2.5 cm) of
space between the sides of the appliance and any adjacent walls.
Avoid direct sublight and heat. Direct sunlight may affect the acrylic coating of the appliance or the
growing cycle of your plants. Nearby heat sources can overheat the unit and cause high internal tem-
peratures that may harm your plants.
Operating Instructions
LEVELING INSTRUCTIONS
Beneath the appliance there are two leveling legs that are located on
either side of the vent. It is important that your unit is level. To level the
unit:
1. Move the appliance to its fi nal location.
2. Have someone gently lean against the front of the unit to take some
weight off the leveling legs.
3. Turn the leveling legs clockwise to raise the unit or counter-clock-
wise to lower it. Continue in this manner until the unit is level.
Fig A
Raises
the Leg
(lowers
the unit)
Lowers
the Leg
(raises
the unit)
2