Go to Google Play or App Store
and download the Danalock App.
When the app is installed you
create a user profile by pressing the
blue ring. You will use this profile
each time you sign into the app.
Next you need to press ”Menu”
in the top right corner, and the
press ”Add lock”.
A guide will now lead you through
the installation and configuration
of your Danalock.
13. Download the Danalock App
Your Danalock is now attached to
the door. Download and open the
Danalock app to finish setting it up.
Leave the door open, so the lock
isn’t influenced when calibrated.
Next you need to press ”Menu”
in the top right corner, and the
press ”Add lock”.
A guide will now lead you through
the installation and configuration
of your Danalock.
14. Add the lock in the app
Pull out the plastic tab
to activate the batteries.
A light will flash to
confirm the Danalock
is ready.
11. Activate batteries
12. Before downloading the app
Note: If the batteries are
disconnected, you will have to
re-calibrate the Danalock.
If at any time you need to dismount
the Danalock from your door, insert
a pen tip into the hole at the top
inner edge of the lock and press
while turning the lock
counter-clockwise until the lock
releases.
This will not reset the lock or
disconnect it from your account, but
the lock may need to be re-calibra-
ted if fastened to your door again.
15. Dismount instructions
page 2/2
Find the small marking on
the edge of the backplate
and align the mark on the
back of the Danalock
baseplate with it.
Now you are sure to hit
the notches on the
backplate with the
Danalock.
9. Align the platemarks
Turn the Danalock
clockwise until it clicks
to fasten it to the back
plate.
NOTE: If you need to
unfasten and retry, see
“Uninstall instructions”
at the end of the
manual.
10. Fasten the Danalock
Click!
Danalock V3 SCANDI Easy install
