Installation Guide Core 256
Doc no. AXCNTR-8001-A-4
Rev. date 201123
Page 15 of 16
and Green LED is
on
Green LED
turns
OFF
“
network, the AX64 will default to IP address
10.0.7.20 / 255.255.0.0 after approx. 2 minutes.
he selection of either of the two recovery modes are fixed after selection. The AX64 will start with a basic boot
software and IP configuration. The AX64 will not be operational until a proper firmware has been downloaded
via the DADman software and it has been restarted. By enabling recovery mode with default IP address and
network configuration the unit can always be identified on a network via the default setup.
Note that the IP address referred to is the IP address of the controller/management interface of the
unit. This is not the IP address of the IP audio interface if a such is installed. This IP address cannot
be accessed in recovery or restore defaults mode.
Specifications
Digital I/O and Synchronisation
Digital I/O formats/ Supported sample rate
Dante™ IP audio and ADAT/SMUX up to 192 kHz
Thunderbolt 3 and MADI up to 384 kHz
DADLink up to 384 kHz
Synchronisation
Word Clock, Video Blac Burst, Dante, ADAT and MADI
Network
Interface
Interfaces
1000BASE-T, RJ45 connector, 4-pair connection
Thunderbolt
3
Interface
Interfaces
2 x USB-C type connectors, supporting link functionality
and 15w power on each port.
DADLink Interface
Interfaces
2 x SFP connectors for Gigabit SFP modules for multi-
mode LC optical fibre connection.
Latency
Below 1 microsecond latency between interconnected
units. The overall latency is defined by the system delay
set for all the units which is normally 7 samples. All I/O
connections across units are 100% aligned in phase.
Channels and Sample rates per link
128 channels
@44.1 and 48 kHz
64 channels
@88.2 and 96 kHz
32 channels
@176.4 and 192 kHz
16 channels
@352.8 and 384 kHz
Double channel count by using two fibre links.
