DAN DRYER FOAMTAP 382, User Manual

Page: 3 / 9

!
D
Ceramic ≥250 mm
Brushed steel ≥300 mm
D
Sensor
WARNING
• Turn off the power to the unit before servicing or cleaning.
• Never modify the product.
• Never insert objects into any opening in the product.
• The product is not intended for playing purposes.
• Cleaning and user maintenance must be carried out by children.
• The product may only be used for the applications described in this manual.
• Do not use any accessories not recommended by the manufacturer.
• The product should be checked on a regular basis. Never use a defective or
malfunctioning unit
• Never make alterations to the product affecting its performance. DAN DRYER’s product
warranty does not cover product problems that result from misuse or alteration.
NOTE
If the power supply cord is damaged, it must be replaced immediately. Disconnect the electricity
supply cord according to instructions.
This product is not intended for use by persons (inclusive children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised
or have been given instruction concerning use of the product by a person responsible for their
safety.
Children should be supervised to ensure this product is used correctly.
GENERAL SAFETY INFORMATION INSTALLATION
• Make sure the main breaker is turned off. Installation must be carried out by a qualified
person in accordance with applicable standards in the country concerned.
2. Mark the desired position on the wall and drill a
Ø35 mm diameter hole.
3. Installation of the tap:
A) Push the screwed bushing through the hole
in the wall
B) Place gasket, disc, and nut on the threaded
coupling of the tap
C) Tighten with tool, be careful not to overtighten
the nut
Recommended wall
thickness: 10-30 mm
Gasket
Disc
Nut
Distance from
sensor to sink:
1. Check the required distance from sensor to sink.
30°
Sensor
Sensor field of view:
Object distance 250 mm: D: ≤128 mm
Object distance 300 mm: D: ≤155 mm
Objects within range D may cause unintentional activation.
160 mm
2. Check the required distance from sensor to sink.
Recommended wall thickness: 10-30 mm
19 mm
≥170 mm
30°
A minimum distance
of 180 mm is required
between each tap
product.
≥180 mm
4 5