4
WARNING
• All units must be equipped with a 3-wire service. Connect the ground wire according
to the instructions.
• This product must be installed only by qualified persons. Use 2.0mm
2
(AWG) NO.14 wiring.
• Turn off the power to the unit before servicing or cleaning. All wires must be disconnected.
• Incorrect installation, defect power cords, or failure to properly ground unit could result in
electrical shock or life-threatening injuries.
NOTE
We do not recommend to install this product above a washbasin. Installation above reflective
surfaces will cause the hand dryer to start on its own. This product is suitable for indoor use
only.
Type Y connection: If the power supply cord is damaged, it must be replaced immediately.
Only qualified persons shall be permitted to replace the cord to avoid a hazard. Disconnect
the electricity supply cord according to instructions.
This product is not intended for use by persons (inclusive children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are
supervised or have been given instruction concerning use of the product by a person
responsible for their safety.
Children should be supervised to ensure this product is used correctly.
GENERAL SAFETY INFORMATION
CIRCUIT DIAGRAM
!
Circuit Board Module
L
N
G/Y
Br
own
Blue
Black
Black
Only 110/120V
Mot
or
Wi
th
Thermal Switc
h 2A
Red
Hea
ter
with Thermo-fu
se
White
VR
FOR SPEED
VR
FOR SENSOR
Sensor module
Transistor
Power Switch
Thermostat
N
MO2HE2
MO1 HE1
L
