Battery charging
The unit’s battery must be recharged before use.
The accessory micro-USB cable
must be used for recharging the unit’s battery.
Connect the appropriate connector on the accessory micro-USB cable to the micro-USB port on the headphones, and the
USB plug on the other end to a USB port on a computer.
When recharging begins, the LED indicator on the headphones will light red.
Full recharging requires about three hours; when recharging is completed, the LED indicator will turn off.
When the battery’s charge is approaching depletion, a
“
Battery low
”
sound will be heard in the headphones at
one-minute intervals.
Note
Battery recharging time and usable battery time may vary depending on ambient temperature and frenquency of use.
Do not place metal ojects near the headphones’ charging contacts, since dangaeraous electical shorts or abnormal
heating may result.
Please don’t attempt to change the rechargeable lithium battery that should last the lifttime of the device.
Pleas
e don’t dispose used batteries/electronics with ordinary solid waste, since they contain toxic substances.
Please turn off your headphone after your usage to get a longer battery life.
Pair headphone with Bluetooth devices
1.
With the headphone power OFF, hold MFB button depressed for three seconds or more to power on and enter the
pairing mode.
The pairing mode is comfirmed by the LED indicator’s flashing blue and red.
2.
When in the paring mode, if pairing is not completed within about five minutes, the power will automaticlly turn off.
3.
Turn on the power to the bluetooth device you wish to pair with, and begin pairing; search for this unit from the paired
bluetooth device.
Set the bluetooth device within one meter to the wireless headphones.
These wireless h
eadphones will appear in the bluetooth device’s display as “Damson HeadSpace”.
4.
Confirm that pairing has been successfully completed with the bluetooth device.
Look at the display for the bluetooth-
enabled device and select “Damson HeadSpace”.
Pairing is confirmed when the LED indicator flashes blue at the intervals of three seconds.
The PIN code for these wireless headphones has been factory set at “0000”. Input this code if requested by the
bluetooth device.
Notes:
1. When the headphone already paired with a device, it will alternately connect when both devices powered on and
stay within 1m. If you want to pair with another device, please disconnect the previous device first.
2. If the pairing is not successful, please switch off headset firstly and then re- pair again.
Noise Cancelling Function
