UNPACKING AND SETTING UP
Unpacking and Assembly
●
Unpack the tile saw and inspect
for any damaged parts.
●
Install the legs in the sockets at the under
side of the water container and fasten with
the knobs. Markings show the right
position.`The wheels on the hind legs
should face outward.
●
Level the tile saw by adjusting the
legs in the sockets and make sure its
stable.
●
Release the transportation lock.
Setting the Cutting Depth:
●
When loosening the Cutting Head
Adjusting Knob, the Cutting Head will
pivot down unless held.
●
Loosen Cutting Head Adjusting Knob
●
Set cutting depth approximately 1/4 inch
below the surface of the Movable Cutting
Table
●
Ensure the Adjusting Knob is tight
Adjustable Cutting Depth
Stop.
The adjustable stop is pre-set for a 10 inch
blade to prevent cutting into the Movable
Cutting Table.
When using smaller blades, the stop can be
adjusted to a cutting depth approximately 1/4
inch below the surface of the Movable Cutting
Table.
Cooling system
Operating the water pump without a sufficient
supply of water may result in pump damage.
●
Place the plug in the drain of the water
container.
●
Fill the container with water until the
water pump is completely submerged.
Connecting to power supply
Before connecting the machine make sure that:
●
the line voltage corresponds with the data
on the machine’s specifications plate,
●
there is a grounded power supply,
●
the extension cord’s meets criterea as
mentioned in the table on page 10.
Transportation Lock
PAGE 12
DALTILE 1020TS OPERATING MANUAL V02/2004R1
1020 22-07-2005 09:04 Pagina 12