44
Spyder3 S3-14 and S3-24 Monochrome Camera User's Manual
03-032-20117-01
Teledyne DALSA
Select Cable
Sets the cable p aram eters.
Camera Link Command
Parameter
Description
Notes
scb i
Ou tp u t com p are valu e. Available
valu es are: 0 to 255.
In m ed iu m configu ration, both cables m u st be
the sam e length.
Only one cop y of this setting is saved in the
cam era (rather than w ith each setting).
On the
lfs
(load factory settings) com m and the
cable length w ill be set to the factory d efau lt of
100.
The cable p aram eter is a relational valu e.
Increase the valu e for longer cables, and
d ecrease it for shorter ones.
Ad ju st the valu e u ntil the test p attern (
svm 1
) is
clean.
get scb
retu rns the cu rrent cable p aram eter.
Example
scb 75
Sensor Output Format
Sensitivity Mode
Sets the camera’s sensitivity mod e. When using high sensitivity mod e, the camera’s responsivity
increases. H igh sensitivity m od e p erm its m u ch greater scanning sp eed s in low light, or allow s red u ced
lighting levels.
Camera Link Command
Parameter
Description
Notes
ssm i
Sensitivity m od e to u se.
0
= Low sensitivity m od e
1
= H igh sensitivity m od e
2
= Tall p ixel m od e
To obtain the cu rrent sensitivity m od e, u se the
com m and
gcp
or
get
ssm
.
The
scd
(set ccd d irection) com m and is not
available in low sensitivity m od e or tall p ixel
m od e.
Example
ssm 0
