Linea HS Series Camera User's Manual
Linea HS Series Cameras
•
13
Specifications
Test Conditions unless otherwise specified:
•
8-bit, 1x gain
•
100 kHz line rate
•
Light source: White LED if wavelength not specified
•
Front plate temperature: +45º C
•
DN = digital number
Specifications not guaranteed when operating in area mode
Common Camera Specifications
The following specifications apply to all models.
Table 4: Common Camera Performance Specifications
Specifications
Imager Format
High speed CMOS TDI
Pixel Size
5.0 µm x 5.0 µm
Pixel Fill Factor
100%
Connectors and Mechanicals
Control & Data Interface
Camera Link HS CX4 or LC
Power
+12 V to +24 V DC, Hirose 12-pin circular
Operating Temp
+0 °C to +65°C (front plate temperature)
Optical Interface
Sensor to Camera Front Distance
12 mm
Sensor Alignment (Relative to sides of camera)
Flatness
50 µm
y
100 µm (Parallelism vs. front plate)
x
± 300 µm (Cross-Scan Direction)
y
± 300 µm (In-Scan Direction)
z
± 300 µm (Along optical axis)
z
± 0.4° (Rotation around optical axis)
Performance
Notes
Analog Gain
1x, 2x, 4x or 8x
Digital Gain
1x to 10x
DC Offset
0 DN
Adjustable
PRNU
< ±2%
At 50% saturation
(1,2)
DSNU (FPN)
< ±2 DN
Integral non-linearity
< 2%
1)
Calibration at 80% saturation, measurements at 50% saturation
2)
Light sources vary spectrally and spatially: re-calibrate cameras in actual system
