28
Falcon2 4M, 8M, and 12M Camera User's Manual
03-032-20107-03
Teledyne DALSA
Saving and Restoring Camera Settings
When the u ser ch anges a cam era p ar am eter, the settings are stored in the cam era‘s
volatile
m em ory and
w ill be lost if the cam era resets or is p ow ered d ow n. To save these settings for reu se, they m u st be saved
to the camera‘s non-volatile memory using the
User Set Save
p aram eter. Previou sly saved u ser setting
(User Set 1 to 4) or the factory settings can be restored u sing the User Set Selector and User Set Load
p aram eters.
Either the Factory or one of the User settings can be sp ecified as the Defau lt Set by selecting it in the User
Set Defau lt Selector. The ch osen set is au tom atically load ed w hen the cam era is reset or p ow ered u p . It
shou ld also be noted that the valu e of Defau lt Selector w ill au tom atically get save in non -volatile m em ory
w henever it is ch anged
The relationship betw een these three settings is illu strated in Figu re 10.
Figure 10: Relationship between the Camera Settings
N OTE: If a test p attern is active w hen you save the
User set
, the cam era w ill tu rn off all d igital p rocessing
u p on restart. For exam p le:
1.
Set the test im age selector to FPN Diagonal Pattern .
2.
Do FPN Calibration and save the coefficient set .
3.
Change the FFC m od e to
A ctiveA ll.
4.
Set the d efau lt selector to
UserSet1.
5.
Save
User Set 1.
6.
Pow er cycle the cam er a.
7.
Reconnect to the cam era throu gh Cam Exp ert .
8.
The FFC m od e w ill be
Off
w hen it shou ld be
A ctiveA ll.
