dallmeier DF2000A, Installation And Configuration Manual

Page: 21 / 41

21
Dallmeier electronic GmbH & Co.KG
7 Preparing to configure
The camera is supplied with factory settings which enable it to be
used for most scenarios without further configuration. However, if
required certain camera properties can be configured using the
camera menu.
The DF2000A can be configured directly on the camera or by means
of the UTC box, the recorder or PView.
NOTE
There must be no video distributor or signal
amplifier between the camera and the UTC
Remote Box (or recorder or PView).
The configuration menus for the camera are shown as follows
according to the various configuration methods:
UTC Remote Box: Press the OK button for approx 3
seconds.
DMS Recorder: Open Camera control and click on
Open/close menu.
PView: Open Camera control and click on
Open/close menu button.
NOTE
Refer to the separate operator’s manuals for the
devices or software used.