© 2018 Dallmeier | www.dallmeier.com
33
Commissioning DDF51(X)0HDV-DN-SM
The specified permissible angle values for the maximum pan, tilt and roll
range are based on the factory default viewing direction of the camera as
shown in the previous figure.
Always loosen both thumb screws
ⓐ
before rolling the lens/sensor unit
around its optical axis (moderately tighten both thumb screws by hand again
when finished).
➡
Connect the camera to your network (e.g. to an IEEE 802.3af compliant PoE
switch or a corresponding PoE midspan device).
➡
Establish an Ethernet connection to the camera with your web browser (see
chapter “Connection and Login” on page 52).
➡
Log in to the camera’s web-based graphical user interface (see section
➡
Open the “Lens control” camera dialog.
➡
Point the camera at your scene.
NOTICE:
Observe the maximum permissible pan, tilt and roll range of the 3-axis
camera gimbal to prevent damage to the device or malfunctions of the
lens/sensor unit caused by pulled plugs or jammed/kinked cables!
➡
Adjust the focal length (zoom) and the focus position in the “Lens control”
camera dialog.
➡
Repeat the last two steps until the captured scene meets your require-
ments.