Commissioning DDF5(X)50HDV-DN-IM
Rev. 2.0.0 | © 2019 Dallmeier | www.dallmeier.com
31
➡
Carefully remove the camera module from the housing.
NOTICE:
Be careful not to damage or disconnect the cables of the camera unit!
➡
Follow the instructions for
Scenario 1
/
Scenario 2
(see below).
➡
Reassemble the camera module at its original position in the housing (do
not forget the toothed lock washers).
Scenario 1: Cabling “Interfaces”
➡
Observe the chapter “Interfaces” on page 40.
➡
Route the required cables through the supplied PG16 cable gland or a
suitable rubber cable grommet.
➡
Screw the PG16 cable gland into the thread on the bottom side of the
housing or insert the rubber cable grommet into the corresponding
through-hole.
➡
Carry out the cabling.
Scenario 2: Inserting a Memory Card
➡
Insert a suitable memory card into the memory card slot (see chapter
“Inserting a Memory Card” on page 44).
Before removing the camera module, remember its original position in the
housing (use the cable entry as a reference point for later correct alignment
during reassembly).
