dallmeier DDF4910HDV-DN-IM, Installation And Configuration Manual

Page: 29 / 104

DF4910HD-DN | DDF4910HDV-DN-IM/-SM
www.dallmeier.com 29
Step 4

Connect the required cables to the connectors of the camera module
(see Fig. 5-7 and chapter “ Pin Assignment ” on page 97).

If necessary, connect a CVBS monitor to the video preview output ( Fig. 5-4 ).

If PoE (Power over Ethernet) is not available, first connect the camera to a suitable
power supply unit and then connect the power supply unit to the mains socket.

Carefully remove the foam ring with the ambient light sensor ( Fig. 5-7 ) from the lens.
Be careful not to tear or bend the cables.

Align the camera with your scene using the 3-axis mount and set the focal length and
focus (loosen the corresponding locking screws before making any adjustments and
tighten them again when finished).

Attach the foam ring back onto the lens while ensuring that the ambient light sensor will
not be covered by the black inner dome cover.

Disconnect the CVBS monitor from the video preview output.

Attach the trim ring to the housing and tighten the 3 housing screws using a T20 torx
wrench.
Housing screw
(T20 Torx)
Locked ceiling clamp Locked ceiling clamp
Suspended ceiling
Trim ring with bubble
Fig. 6-6
6.2.2 Surface Mount Variant (SM)
The housing base is mounted with 3 screws (Ø 4 mm) to the ceiling/wall.
You need:
• T20 torx wrench
• Marking tool (e.g. awl)
• 3 mounting screws (Ø 4 mm)
•
3 anchors
• Electric drill
• Screwdriver