Dali Zensor AX, User Manual, Page: 8 / 38

12
1.0 INTRODuCTION
Congratulations with your new DALI ZENSOR AX loudspeaker. It is important to us that your new
DALI loudspeakers are set up and connected optimally. For this reason, we recommend that you
read this manual and follow its recommendations. The manual contains instructions for setup
and connection, as well as tips and advice on how to get the most out of your new loudspeakers.
DALI is acclaimed around the world for unique loudspeakers built to our uncompromising
standards for design and performance. The goal for every single DALI loudspeaker is always
our foremost commitment: To create a listening experience in your home that will make you
forget time and place.
Remember to sign up for the DALI newsletter at www.dali-speakers.com.
Enjoy!
2.0 uNPACKING
Be careful not to damage the contents when you unpack the parts. Depending on which DALI
ZENSOR AX model you have bought, different accessories come with the loudspeaker. Check
that all parts are contained in the cardboard box (see Table 1). Keep the packaging materials
should your speaker need to be relocated or serviced.
3.0 POSITIONING
To achieve the best results, the loudspeaker setup should be symmetrical round your favourite
listening position, see Figure 1. We recommend that you experiment with the position of your
loudspeakers – the sound quality will change depending on the loudspeaker position. Objects
positioned between the speaker and the listening position might negatively affect sound quality.
The speakers are designed to meet our wide dispersion principle, so they should NOT be angled
towards the listening position, but be positioned parallel with the rear wall, see Figure 2. By
parallel positioning, the distortion in the main listening area will be lowered and the room
integration will be improved. The wide dispersion principle will ensure that sound is spread
evenly within a large area in the listening room.
3.1 DaLI ZeNSor 1 aX
ZENSOR 1 AX is designed to be positioned close to the wall. The speaker can be positioned on
a stand/shelf or hung on a wall using the integrated wall bracket. If positioned on a stand or
shelf, the enclosed small rubber bumpers can be mounted under the speaker for stable and
vibration free positioning, see Figure 3A. If hung on a wall, mount the larger bumpers on the
rear edges of the speakers. The speakers are hung on a wall using one screw (be sure to use
a screw appropriate for the wall type) mounted in the wall. The screw must fit the wall bracket
on the rear side of the speaker, see Figure 3B.
The ZENSOR 1 AX should ideally be positioned, so that the height of the tweeter is approximately
at ear height when seated in your favourite listening position.
3.2 DaLI ZeNSor 5 aX
ZENSOR 5 AX is designed as a floor standing speaker. ZENSOR 5 AX can be used with spikes or
rubber bumpers under the speaker, see Figure 3C/D. Be careful not to over tighten the locking
nuts. Spikes or rubber bumpers can improve the sound quality. You can try both to hear what
gives the best sound quality in your setup. Please be aware, that spikes may damage the floor,
if it is not protected by e.g. coins under the spikes. They should be positioned minimum 10 – 20
cm (4 – 8”) from the rear wall.