Dali SUB P-10 DSS, Manual

Page: 11 / 14

13
UK
5.7 REMOTE CONTROL (see Figure 4)
A) Standby ON/OFF
Press to toggle between the two states (ON/OFF switch on the rear panel must be set to ON).
NOTE: When the AUTO/MANUAL switch is set to AUTO, the subwoofer cannot be turned off with
signal on the inputs.
B) Mute
Press to mute the subwoofer. The display on the front of the subwoofer will show “---”.
Press again to un-mute the subwoofer.
C) Cinema/Hifi mode
Press the CINEMA/HIFI button to toggle between the two sound modes. The display on the front
of the subwoofer will show the selected sound mode.
D, E, F) Phase, frequency and volume adjustment
Press the relevant button and adjust to the desired value using the ‘+’ and ‘-’ buttons. The
display on the front of the subwoofer will show the selected value:
FREQUENCY RANGE: 40 - 120 Hz
VOLUME RANGE: 0 - 30 dB
PHASE RANGE: 0°, 90°, 180° or 270°
G) Memories 1, 2 & 3
When you have adjusted Sound Mode, Frequency, Volume, and Phase to the desired values, they
can be stored in and recalled from the memory positions 1, 2 and 3.
To store a preset: Press and hold the desired memory button (1, 2 or 3) for more than 3
seconds. When the values are stored as a preset, the subwoofer display will confirm by
flashing “-1-”, “-2-” or “-3-” as well as the sound mode three times, according to the
memory you have selected.
Please note that existing presets in the memory will be overwritten, if settings are restored in
one of the memories.
To recall a preset: Briefly press the desired memory button (1, 2 or 3). When a preset is recalled,
the subwoofer display will show “-1-”, “-2-” or “-3-” as well as the sound mode according to
the memory you have recalled.
H) Battery
Open the battery compartment on the remote and insert the battery as on the illustration (see
Figure 5). When the battery needs to be replaced (depends on frequency of use), use ONLY a
lithium cell battery type CR2025,3V.
ATTENTION! Keep the remote out of reach of children.