The SUB S-100 subwoofer can be mounted in stud (dry wall) and
plasterboard constructed walls with a minimum free depth of 102
mm (4.02 in). The minimum and maximum plasterboard thickness that
can be accommodated by the SUB S-100 subwoofer fixings is 10 mm
(0.4 in) and 50 mm (2.0 in) respectively. The SUB S-100 subwoofer
also requires 19 mm (0.74 in) free space to the side, top and bottom
in order to enable its dogleg clamps to be deployed. Diagram 5
illustrates SUB S-100 installation dimensions.
If SUB S-100 is to be installed in a particularly thick wall, it may be
necessary to dismount its dogleg clamps from their screws then and
replace them. Dogleg clamps make it possible to install SUB S-100 in
a wall up to 70 mm (2.75 in) thick.
The supplied cut-out template can be used initially to visualise
where a SUB S-100 is to be installed. As part of this exercise, use
a wall stud and pipe/cable finding tool to ensure that the wall space
in which a subwoofer is to be installed is free of obstructions. It is
also important to ensure that the 102 mm (4.02 in) minimum depth
clearance required for SUB S-100 subwoofers is available. If the free
depth available at the installation position is unknown, a test hole can
be drilled and a depth measuring gauge inserted.
DIAGRAM 5:
SUBWOOFER INSTALLATION DIMENSIONS
615 mm
24.2 in
Min.
19 mm
0.75 in
Min.
102 mm
4.02 in
370 mm
14.6 in
Minimum depth
102 mm
4.02 in
Max. 50 mm / 2 in
Min. 10 mm / 0.4 in
Reversed doglegs
Max. 70 mm / 2.8 in
Min. 30 mm / 1,2 in
4.2.2 Wall Aperture
10
