DALBO 400, Operator'S Manual

Page: 23 / 27

MAXIDISC
Side 23
Replacing shaft, bearings and T-rings
Lower the MAXIDISC to the ground. Securely support and block the roller if neces-
sary.
Watch out for unintentional rolling movement when the bolts in
the bearings have been removed.
Fig. 11
1 Remove the bolts in the bear-
ings.
2 Roll the shaft with the T-rings
away from the frame.
3 Loosen the set screws in the
bearings and slide the bear-
ings off the shaft.
4
Pull the T-rings and the square
tube of the shaft.
Mount in reverse order.
 •
Apply Loctite to the set screws in the bearings
•
When mounting the shaft with bearings, make sure to posi-
tion the bearings with the grease fittings facing towards
the back, enabling easier access for lubrication and pro-
tecting them from stones.
Replacing the bearing in the disc hub

The MAXIDISC must be securely blocked and supported before pull-
ing the disc leg out of the gang tube.
Fig. 12
1 Remove bolts (A) and (B).
2 Pull the disc leg out of the gang
tube.
B
A