4
Putting the appliance into operation
Seite | 40
To maintain the softening function, the appliance periodically regenerates the water
softening system. Each regeneration requires an additional 2 litres of water, energy
consumption increases by 0.02 kWh and the program is extended by 4 minutes.
4.2 Filling/topping up regenerating salt
Add regenerating salt before using the appliance for the first time. Observe the following
when filling the salt container:
✓
Only use regenerating salts specially made for dishwashers.
✓
The manufacturer will decline all liability for damage caused by the use of
unsuitable salts and the warranty will be voided.
✓
Fill in regenerating salt before putting into operation.
➢
When using multi-tab detergent with regenerating salt, it is not
necessary to add regenerating salt.
➢
Do not pour in regenerating salt if the water hardness in the
residential area is 0-5° dH.
13.
Remove the lower basket and unscrew the lid of the salt container.
14.
When using for the first time, fill the salt container with approximately 1 litre of
water.
15.
Position the funnel and pour in approx. 1.5 kg of regenerating salt. It is normal
that a certain amount of water runs out of the container as the salt is added.
16.
Absorb spilt regenerating salt immediately with a damp cloth.
17.
Fit the cover correctly and screw it on as far as it will go.
18.
Start a washing programme immediately after filling.
Normally, the low-salt indicator switches off after running a washing programme.
Fill up with regenerating salt when the "Salt indicator"
lights up.
APPLIANCE DAMAGE!
•
Never pour detergent into the salt container. Damage to the water softening
system.
•
Take care never to put the wrong powder in the salt container. A defect of the
water softening system is likely.
•
Tighten the salt container lid properly. If dishwasher detergent penetrates the salt
container, the water softening system will be damaged.
•
Do not leave spilled regenerating salt in the appliance. This will damage the
appliance.
ATTENTION
