– 18 –
Change the
Color Adjustment
settings, the
Source Dimensions
, and the
Target
Dimensions
.
Blank
Select
Blank
from the drop-down menu to cause the display to show a blank output.
Output
Output
sets the entire display output as
Active
or
Inactive
.
Displays can be configured to use primary and
backup processor systems. If the processor
system is the primary system, the
Output State
should be set as
Active
. If the processor system
is the backup system, the
Output State
should
be set as
Inactive
. Both primary and backup
systems cannot be set as
Active
at the same
time.
Note:
If the
Output State
is not set as
Active
and there is no backup system, the display
will be blank.
If the
Output State
is set to
Active
and the display system has more than one face, the
operator can also set specific display faces as either
Active
or
Inactive
. This option may
be used in a venue with a four-sided centerhung display where the three display faces
facing the audience are set as
Active
and the fourth face (the one facing the
performer) is set as
Inactive
. Refer to
The
Boot Sequence
drop-down menu allows
the operator to select what is shown during the
display’s startup procedure. Refer to
.
• Full
mode shows the description, display
dimensions, color depth, time zone, list of
communication services, firmware version, and the IP address. Playback begins after
this is shown.
Full
is the default mode.
• Compact
mode shows only product and version information. Playback begins after
this is shown.
• None
mode shows no information and playback starts immediately following start-up.
The
Green Mode
percentage field and slider
bar sets a threshold for dimming the content
shown on the display.
This option is used to conserve power by
adjusting content dimming when it exceeds
the maximum threshold limit. If full-motion video
is displayed, this setting should be 100 percent. Refer to
.
The
Gamma
number field and slider bar adjusts the image’s middle ranges of color but
does not alter its full white or black values.
Figure 36:
Output State - Multiple Faces
Figure 37:
Boot Sequence Mode
Figure 38:
Output - Green Mode & Gamma