Daktronics Tuff Sport TN-2560, Installation Manual

Page: 12 / 42

Electrical Installation
8
Single-Court Scoreboard Signal Connection
Reference Drawings:
Signal Connection; Installation ........................................................................... DWG-28124
System Riser; Tennis; Single Court w/ TNMC, AS 5000 ..................................... DWG-177098
For single-court scoreboards using a wired All Sport 5000 setup, signal installation requires
routing control cable from the scoreboard control console to a signal junction box
(J-box) near the display. Refer to DWG-28124 and DWG-177098 in Appendix A for signal
wire connection. At a minimum, use a paired, 22 AWG shielded cable (part # W-1077).
1� Connect the cable to a 1/4" J-box at the control console end.
2� Route the cable in conduit from the J-box on the control console end to a J-box near
the display.
3� Install the 1/4" phone plug (part # 0L-40683) to the display end of the cable. Be sure
to connect the cable shielding only in the J-box on this end. DO NOT connect cable
shielding at the J-box near the control console.
4� Insert the plug into the J31 – SIGNAL IN jack located on the top of the display.
5� Connect a signal cable from the J-box on the control console end to the J1 , J2 , or J3
jack on the back of the All Sport 5000 console.
Multi-Court Scoreboard Signal Connection
Reference Drawings:
System Riser; Tennis; Multi-Court, RC-100 Direct .............................................. DWG-233254
System Riser; Tennis; Multi-Court, RC-200 Direct ............................................ DWG-3641206
Connect a 1/4" phone plug cable between the J32 – SIGNAL OUT jack on the first
scoreboard section to the J31 – SIGNAL IN jack on next scoreboard section. Repeat this
process to connect all scoreboard sections. Refer to DWG-233254 (RC-100) or DWG-
3641206 (RC-200) in Appendix A .
For the Team Score sections, route the digit
cables though the holes in the sides of the
cabinets, and connect them to the mating
jacks on the driver or sectional interconnect
cables. Optional Team Name Message Centers
(TNMCs) use power/signal interconnect cables.
Refer to Figure 9 and the table at right.
2-Section Team Score
3-Section Team Score
Driver
J52 J50
J53 J51
(From GUEST Score Digit)
(From GUEST TNMC)
P52
P53
(From GUEST Score Digit)
(From GUEST TNMC)
Driver
J53 P53
J52
P52
(From HOME Score Digit)
(From HOME TNMC)
P50
P51
Figure 9: Team Score Connections
Model Connection Plug > Jack
Two
Section
Guest TNMC P52 > J52 (5-pin)
Guest Score P53 > J53 (9-pin)
Three
Section
Home TNMC P50 > J50 (5-pin)
Home Score P51 > J51 (9-pin)
Guest TNMC P52 > J52 (5-pin)
Guest Score P53 > J53 (9-pin)