Daktronics ST-3170, Manual, Page: 21 / 50

Mechanical Installation
17
Multiple Table Connection
If more than one scorers table is to be used as part of a single display face, they must be
lined up in the appropriate arrangement and connected together. One table attaches
to another using two latches on the right side of the table (as viewed from the rear) and
the provided 5/16" T-handle hex wrench (part # TH-1088).
To attach the tables together, follow the steps below:
1� Locate the section number on either side of the table. Refer to Figure 31 . The farthest
right table (when viewed from the rear) will typically be labeled “101”, then the next
table to its left will be “102”, and so on.
Figure 31: Section Number Label Location
2� Move the table labeled "101" into position, set the Caster Base Tool in place, and lift
up the tabletop as described in Table Setup – Transport to Stationary Mode (p�10) .
3� Position the tables together as described below and shown in Figure 32 :
a� Move the table labeled
"102" into position as close as
possible to the right side of
table "101" (as viewed from
the front).
b� Lower the end of table "102"
farthest from table "101".
c� Lower the end of table "102"
closest to table "101".
Note: If the tables are overly
difficult to reposition, try
adjusting the front and
rear caster wheels as
shown in Figure 17 and
Figure 21 .
4� With the table labeled "102" in position, set the Caster Base Tool in place, and lift up
the tabletop as described in Table Setup – Transport to Stationary Mode (p�10) .
Figure 32: Multiple Table Positioning