SSP-100 Portable Speaker System Quick Guide
DD4941643
Rev 00
14 September 2021
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Page 1 of 2
This guide explains the setup of a Daktronics SSP-100 portable
speaker system. Refer also to this short YouTube video:
Important Notes:
•
Do not use if wind may potentially knock down speaker/tripod!
•
Do not use in wet conditions!
•
Do not allow amplifier to get wet!
Equipment Setup
1.
Loosen the tripod leg fitting knob.
2.
Extend the tripod legs, and then re-tighten the knob.
Note:
Tripod legs should be spread as far outward as possible
(braces parallel to floor) for best stability.
3.
Use the side handles in the speaker cabinet to lift it up, align the
mounting hole in the bottom of the cabinet with the tripod, and
gently place it atop the tripod.
4.
Use supplied power cord to connect the speaker to 120 VAC
power and turn on the
POWER
switch. If using an extension cord,
ensure cord is long enough that the speaker can be raised
without pulling on power cords!
5.
Firmly grip the handle and loosen the height adjustment knob
to carefully raise the speaker. The pressurized gas shock allows
the speaker to rise with very little effort. Once at the appropriate
height to reach the intended audience, re-tighten the knob.
Leg Fitting
Knob
Height
Adjustment
Knob
Handle
