Daktronics Sportsound SSR-300, Operation Manual

Page: 18 / 42

14 Setup & Operation
3.6 Wireless Mic System Operation
Basic instructions are described below. For more information about wireless mic system operation, refer to
the
Shure
®
QLX-D
®
Wireless System User Guide
.
Note: For systems built prior to January 2015, refer to the Shure
®
ULX
®
Wireless System User Guide for
setup and operation instructions.
Wireless Receiver
The unit displays the following information ( Figure 24 ):
a. Transmitter Battery Life
b.
TV Channel
c. Frequency
d.
Group Number
e. Channel Number
f.
RF Signal Strength
g. Transmitted Audio Level
h.
Gain Level
Single Receiver
1. Ensure all transmitters are powered off. Press the power button to turn on the receiver if it is not
already on.
2. Press menu until “scan” displays on the LCD.
3. Press enter to start frequency scan. When scan is complete, Group and Channel will display on
the LCD.
Network Receivers
1. Ensure all transmitters are powered off. Turn on all receivers and wait one minute to allow time to
connect to the network.
2. Press menu on one receiver until group number flashes.
3. Use the arrow buttons to select a group to scan.
4. Press enter , wait for channel, and then press enter again
5. Press menu until “network scan” displays on the LCD.
6. Press enter twice to deploy channels to other receivers.
Note: Perform a scan on all of the wireless units just minutes before the game! If a scan is performed too far
ahead of time, frequencies set up by the media later on may interfere with previously configured wireless
microphone settings.
Power IR Window
a
e
b c
d
g
f
h
Power
ON/OFF
Power
ON/OFF
IR Window
Figure 24: Wireless Receiver LCD & Controls