Daktronics P2345, Display Manual

Page: 31 / 38

REV: DATE: DESCRIPTION: BY:
THE CONCEPTS EXPRESSED AND DETAILS SHOWN ON THIS DRAWING
ARE CONFIDENTIAL AND PROPRIETARY. DO NOT REPRODUCE BY
ANY MEANS WITHOUT THE EXPRESS WRITTEN CONSENT OF
DAKTRONICS, INC. OR ITS WHOLLY OWNED SUBSIDIARIES.
COPYRIGHT 2021 DAKTRONICS, INC. (USA)
THIRD ANGLE PROJECTION
PROJECT:
TRANSPARENT SHOT CLOCKS
TITLE:
COMPONENT ACCESS; BB-216*
DATE:
30-AUG-21
DIM UNITS:
INCHES [MILLIMETERS]
SHEET REV
SCALE:
1/10 DO NOT SCALE DRAWING 00
DESIGN:
JCOOK
JOB NO. FUNC - TYPE - SIZE
4934070
DRAWN:
JCOOK P2345 E - 10 - A
TO ACCESS THE DIGITS:
1. LOOSEN THE SET SCREWS AROUND THE PERIMETER
OF THE DISPLAY, BOTH SIDES, USING 1/16" HEX WRENCH.
DO NOT REMOVE THE SET SCREWS, JUST LOOSEN THEM.
2. REMOVE 16 SCREWS FROM UPPER CORNERS OF THE
DISPLAY. THERE ARE 4 IN EACH CORNER, BOTH SIDES.
3. REMOVE THE 4 SCREWS FROM UPPER SIDES OF THE
DISPLAY.
4. LIFT THE TOP APPROXIMATELY 6".
5. REMOVE THE SHIMS THAT ARE PLACED BETWEEN THE
POLYCARBONATE AND THE FRAME.
6. DISCONNECT THE LED LIGHT STRIPS ATTACHED TO
THE TOP FROM THE WIRING HARNESS INSIDE THE SHOT
CLOCK FRAME.
7. SLIDE THE POLYCARBONATE / DIGIT STACK UP
CAREFULLY.
8. DISCONNECT THE HARNESS FROM THE DIGITS.
9. LIFT THE POLYCARBONATE / DIGIT STACK OUT THE
FRAME.
10. SEP A RATE THE POLYCARBONATE STACK TO ACCESS
THE DIGITS.
11. REPLACE THE DIGIT PANELS AS NECESSARY.
12. COMPLETE THE STEPS ABOVE IN REVERSE ORDER
TO REASSEMBLE THE DISPLAY.
CAMERA MOUNTS NOT
AVAILABLE ON BB-2161
SET SCREWS. STEP #1
SCREWS. STEP #2
SCREWS. STEP #3
POLYCARBONATE /
DIGIT STACK
FRONT VIEW
PPaarrtt ## -- 00AA--22334455--00000055 VVeerrssiioonn -- AA..77 D Deessccrriippttiioonn -- FF.. AASSSSYY;; BBBB--22116600 W W// C CAAM MEER RAA M MO OU UN NTTSS LLiiffeeccyyccllee SSttaattee -- C Coonncceepptt LLaasstt M Mooddiiffiieedd BByy -- jjccooookk LLaasstt M Mooddiiffiieedd -- 22002211--0088--1100