Daktronics OMNISPORT 2000, Operation Manual

Page: 22 / 182

Timing System Setup
12
Connecting the Horn Start System
• Connect the lane speaker cable into the LANE SPEAKERS jack on the HS-200. If an
auxiliary speaker is used, connect the cable from the desired speaker location to the
AUX SPEAKER jack on the HS-200.
• Connect the 30’ (9.1 m) start cable between the START (normally open) jack on the
HS-200 and the J12 START INPUT jack on the rear of the OmniSport 2000.
• If using the HS-200 with an Omega
®
timing console, connect the start cable from
the console to the N/C (normally closed) jack on the HS-200.
• If using the HS-200 with a Colorado Timing System (CTS) console, connect the start
cable from the console to the START (normally open) jack on the HS-200.
• For HS-200 units with a wired mic, connect the mic into the 4-pin jack labeled MIC .
For additional information about horn start setup and operation, refer to the HS-200
Owner’s Manual (ED-12935) , available online at www.daktronics.com/manuals .
Connections on the Console
Reference Drawings:
Connector Designations: OmniSport 2000 ...................................................... DWG-154282
Become familiar with all connections on the rear of the OmniSport 2000 timing console
as shown in Figure 23 and DWG-154282� Make all connections to the OmniSport 2000
console and attached equipment before turning on the POWER switch.
Figure 23: OmniSport 2000 Console Rear View
Figure 21: HS-200 w/ Wireless Mic
Figure 22: Lane Speaker