Daktronics OMNISPORT 2000, Operation Manual

Page: 126 / 182

Water Polo Mode Operation, Menus, & Settings
116
• If a custom RTD port number is required, press [2] . Press
the [0]–[9] keys to enter a new value and press [ENTER] .
To select a standard port number instead, press [CLEAR]
twice to exit the menu.
MAC Address
This menu allows the operator to verify the MAC address of
the console. The MAC Address cannot be edited. Press any
key to exit the menu.
MAC ADDRESS
09:EC:03:01:06
From Main Menu – [3]>[6]>[6]
Test Menu
The OmniSport 2000 timer is equipped with features that test
battery level, and the numeric scoreboard. The following
submenus explain how to use each of these tests.
Battery Test
This menu checks the battery power level.
BATTERY TEST
LEVEL= CHARGED
From Main Menu – [4]>[1]
BATTERY TEST
LEVEL= LOW
The battery level will show as CHARGED or LOW . Press [ENTER] to exit the menu.
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle ON/OFF
This menu checks the signal to the scoreboard.
DISPLAY ALL ON
ENTER TO EXIT
From Main Menu – [4]>[2]>[1]
Press [1] to toggle the scoreboard ON and OFF . When this menu is selected, an all ON
signal is sent at intervals of approximately 3 seconds. Press [ENTER] to exit the menu.
Driver Address
This menu shows which addresses each of the drivers on the
scoreboard are set to. The addresses were set when the
display was installed.
SHOWING ADDRESS
ENTER TO EXIT
From Main Menu – [4]>[2]>[2]
Press [2] to display the driver addresses. Press [ENTER] to exit the menu.
CUSTOM
PORT#- 18000*
MENU-NETWORK
6-MAC ADDRESS
MENU-MAIN
4-TEST MENU
MENU-TEST
1-BATTERY
From Main Menu – [4]
MENU-TEST
2-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
From Main Menu – [4]>[2]
SB TEST MENU
2-DRIVER ADDRESS