DD5075265
Rev 00
3 June 2022
NPN-X200/X400 Series Speed Frame Substructure & Panel Quick Guide
Page 1 of 4
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Frame Installation
Install First Frame
Note:
These steps are easiest with two to three people.
1.
Identify the stud locations on the wall. Use a level to draw lines the
height of the display and mark the studs.
2.
Identify the position of the bottom-center frame.
3.
Cut the zip ties from the first frame. Test each bolt assembly to verify
that it slides freely.
Note:
If the assembly binds, tap a hammer on the side of the steel
plate to break it loose.
4.
Mark the location for the perimeter of the frame on the wall. Use this
mark to position the first frame. Hold the frame in place on the wall and
use a 4' level on top of the frame while positioning it. Refer to
.
5.
Slide the bolt assemblies to the nearest stud lines.
6.
Install the supplied TEK screws (Daktronics part number HC-3979953)
through hollow bolts into the respective studs. Start with the frame
corners first, and fill in remaining available screws. Refer to
.
Note:
Do not tighten the screws.
Figure 1:
Position Frame on Wall
Figure 2:
Install TEK Screws in Remaining Bolt Assemblies
7.
Install the brace plate (Daktronics part number 0M-4951150) after
starting a screw in the stud.
Note:
Ensure that the brace plate is positioned on the screw and
lands between the wall and the tip of the hollow bolt. The
brace plate provides a strong surface to adjust the z-axis
position of the frame. If the brace plate is not placed properly,
the tip of the hollow bolt will cut and sink into the wall material.
8.
Tighten the screws until the frame is fixed in place.
9.
Use a level on the top and side of the frame and repeat
Steps 6
for the remaining bolt assemblies.
10.
Place a level on the face of the vertical members in the frame to
ensure the frame is plumb and level. Adjust the Z-position of the frame
as needed. Refer to
Note:
Ensure the frame position aligns to the marked location on the
wall.
Adjust Frame Z-Position
1.
Identify the bolt assembly locations to adjust away from the wall. Refer
to
Figure 3:
Identify Bolt Assemblies to Z-Adjust
Check level on all
vertical members
2.
Adjust one bolt assembly at a time.
Refer to
a.
Loosen the TEK screw.
b.
Tighten the hollow bolt into the
threaded plate until the end
of the bolt braces against the
brace plate. Continue until the
face of the frame is level.
c.
Tighten the TEK screw to lock the
Z-position in place.
1
2
1:
Sheetrock
2:
Backer plate
3:
TEK screw
4:
Fully adjusted bolt
5:
Hollow bolt
6:
Threaded plate
4
5
3
6
Figure 4:
Adjust Z-Position of Bolt
Assembly
