Daktronics GALAXY ECCB Series, Installation And Operation Manual

Page: 5 / 41

Introduction
1
1 Introduction
This manual provides the necessary information to install and service a Daktronics
Galaxy
®
eCCB (electronic changeable copy board) display.
Please read and understand all steps in this manual before beginning the installation
process.
For a smooth installation, complete the steps in this manual in order. Contact Daktronics
Technical Support with any questions before or during the installation process.
Limitation of Liability
The factory warranty will be nullified if:
• The display is not installed according to the
steps in this manual
• Proper electrical service is not provided or the
display is not grounded properly
• Unauthorized modifications are made to the
display, display cabinet, or the control system
Refer to Section B: Daktronics Warranty and Limitation of Liability (p�37) at the end of
this manual for the full Daktronics Warranty and Limitation of Liability.
Contact Information
For assistance before, during, or after display installation, please contact Daktronics
Technical Support: 800-DAKTRONICS (800-325-8766).
Model Number Guide
Daktronics Galaxy
®
eCCB model numbers are defined as follows:
ECCB-A100-XFTxXFT-M-R-F
ECCB
= Electronic changeable copy board
A100
= Product generation
X FT
= Feet high
X FT
= Feet long
M
= Pixel pitch in millimeters
R
= LED Color
F
= Face setup: SF – Single Face or 2V – Primary/Mirror
Figure 1 shows a label on the
display's back where the model
number and power requirements
are located.
Displays are either single face (SF)
or two view (2V). In 2V units, the first
display is referred to as the primary
and the second is called the mirror.
GENERAL PURPOSE
RETROFIT SIGN
CONVERSION
FOR USE ONLY
IN ACCORDANCE WITH
KIT INSTRUCTIONS
KIT IS COMPLETE ONLY WHEN ALL PARTS
REQUIRED BY THE INSTRUCTIONS ARE PRESENT
CERTIFIED
SAFETY US-CA
E469414
Figure 1: Display Label