Daktronics GALAXY ECCB Series, Installation And Operation Manual

Page: 35 / 41

Replacing Parts
31
4� Loosen the screws that hold the Wi-Fi router bracket to the display backsheet. Slide
the bracket upward
and remove it and the
router from the display.
5� Slide the Wi-Fi router
cover downward to
remove it. Refer to
Figure 26 .
6� Disconnect the
Ethernet cable from
the Wi-Fi router
by pressing in the
Ethernet connector
tab and pulling the
cable free. Refer to
Figure 27 .
Install New
Access Point and Antenna
1� Use a needle nose pliers to install the new
antenna cable on the top of the display.
2� Remove the router cover and white grommet
from the bottom of the new router.
3� Thread the Ethernet cable through the hole at
the bottom of the router bracket and through
the router cover. Refer to Figure 29 .
4� Connect the Ethernet cable to the Wi-Fi router
by pressing in the Ethernet connector tab and
pushing the end of the cable firmly into place.
5� Replace the router cover and thread the
stabilizing piece onto
the router. Refer to
Figure 30 .
Figure 26: Remove Router Cover
Figure 27: Disconnect Ethernet
Cable
Figure 28: Replacement Router Kit Parts
Figure 29: Thread Ethernet Cable
Through Bracket Hole
Figure 30: Attach Router Cap