Note:
The cable from the enclosure to the display can be routed though conduit, or
should be secured to prevent being pulled loose from the display by weather or
vandalism.
1.
Mount the enclosure within 30 feet of the display.
2.
Route signal from the signal converter to the watertight enclosure at the
base of the display. Connect the cable to the signal converter and at the
enclosure as shown in
3.
.
4.
Connect the quick connect cable from the enclosure to the primary display
at J32.
5.
Ground the RS422 signal enclosure.
Figure 24: Signal Converter to Surge Board Assembly Enclosure
Signal Converter to Surge Board Assembly
Signal Converter
(J4/J5)
Field
Cabling
Surge Board
Assembly
TB1 (RS422 In)
Pin 1 (GND)
Shield
Pin 1 (NC)
Pin 2 (RX-P)
Red
Pin 2 (TX-P)
Pin 3 (RX-N)
Black
Pin 3 (TX-N)
Pin 4 (TX-P)
Green
Pin 4 (RX-P)
Pin 5 (TX-N)
White
Pin 5 (RX-N)
Pin 6 (GND)
Pin 6 (NC)
Electrical Installation
3-11
