Daktronics Galaxy AF-3050 Series, Display Manual

Page: 14 / 87

2.3 Lifting the Display
The top of the display is equipped with eyebolts that are used to lift the unit. Take special care not to
exceed the rated load of the eyebolts. Refer to the information at the end of this section to determine
the allowable load of the eyebolts.
Figure 7 below illustrates both the correct (left example) and the incorrect (right example) method
of lifting a display. By using the non-recommended form on the right, the eyebolt may break. Lift the
display as shown on the left, with the lifting bar. Use every lifting point provided.
Do not attempt to permanently
support the display by the
eyebolts.
Figure 7: Lifting the Display
If removing the eyebolts,
adequately seal the holes using 13
bolts and sealing washers, ½ inch
in size. Silicone along the threads.
This ensures that water does not
enter the display.
2.4 Display Cabinet Mounting
1. Carefully uncrate the display. Look each side of the display over for signs of damage during
shipping.
2. Following the guidelines described in Section 2.3 , lift the display into position on the support
structure.
3. Because mounting design will vary for the sign, Daktronics cannot provide additional detailed
information. Follow the instructions provided by the sign company for mounting your particular
sign(s).
4. Refer to Section 1 for information on routing power and signal.
Refer to
Section 3 for wiring instructions.
Mechanical Installation
2-2