FLR3-100/400 Key Fob
30
Option 2: Single Branch Circuit for All Fuelight Systems
Use this option when a single branch circuit is wired to all pylons and Fuelight systems.
All Fuelight systems turn off and on simultaneously requiring access to the inside of the
host display of each Fuelight system to sync to its dedicated key fob.
1�
In the host display of each Fuelight system, unplug the driver power supply.
2�
Power up the first Fuelight system by reconnecting the power supply to the driver.
3�
Sync the key fob per
Pair Key Fob with Display (p�14)
4�
After the first Fuelight system and key fob are synced, disconnect the power supply
from the driver
after 5 minutes
.
5�
Power up the second Fuelight system by reconnecting the power supply to the driver
and sync that key fob.
6� Unplug the power supply from the driver after 5 minutes�
7�
Repeat this step for additional Fuelight systems.
8�
Once all key fobs are synced and marked to designate which Fuelight system they
control, reconnect all power supplies to their drivers in all host displays.
9�
Key fob synchronization is complete.
10�
Map the lines of all of the displays in each of the Fuelight systems per
• If there are multiple pylons, repeat the steps above for each pylon.
• Make sure only one pylon is powered on at a time.
