FLR3-100/400 Key Fob
26
7 FLR3-100/400 Key Fob
Map Line Numbers
Each display must be set to the correct line number to show the correct price when
pressing the LINE buttons on the key fob. To map the line number for each display, follow
these steps:
1�
Make sure all price displays are powered on.
2�
Press and hold the
LINE 2
plus (+) and minus (–) buttons at the same time for ~5
seconds. The host display (with the radio antenna connected to it) will begin to dim
and brighten or the decimal will begin to flash.
3�
While the display slowly flashes, press the
LINE 2
plus (+) button until the appropriate
line number is shown on the display (L01, L02, etc).
4�
Once the line number is set, press and hold the
LINE 2
plus (+) and minus (–) buttons
until the next display face begins to slowly flash.
5�
Repeat these steps until all display faces have been correctly mapped.
Note:
If a display is set incorrectly, first complete the process with the remaining
displays, and then cycle back to the first display to make corrections.
6�
Exit configuration mode by pressing and holding the
LINE 2
plus (+) and minus (–)
buttons for ~5 seconds until the displays show prices and they no longer flash.
Note:
All displays are programmed with a default price matching their line number.
Use this to identify that all displays are addressed correctly.
Configure Numbers
To configure the numbers six and nine as well as the
fraction display preferences, follow these steps:
1�
Make sure all price displays are powered on.
2�
Press and hold the
LINE 3
plus (+) and minus (–)
buttons on the key fob until all displays show the
numbers 6 and 9. The number scheme will be either
3.69 9/10 or 4.69 9/10.
3�
Press the
LINE 3
plus (+) and minus (–) buttons to scroll
through the different number configuration options.
• For Domestic displays with a 9/10 digit, the
number 3 needs to show in the first column for the
.
• For International displays, make sure the number
4 shows in the first column for the desired format.
International displays offer two configuration
options: tails and 9 or no tails and 9. Refer to
.
4�
When the desired number configuration is shown on
the displays, press and hold the
LINE 3
plus (+) and
minus (–) buttons to exit configuration mode.
No Tails and 9
No Tails and 9/10
Tails and 9
Tails and 9/10
Figure 59:
Digit Configurations
No Tails
and 9
Tails and 9
Figure 60:
International Digit
Configurations
