4G Modem With Quick Connect Installation
Quick Guide
DD3486291
Rev 06
28 November 2018
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Page 3 of 3
LED
Color/Pattern
Description
LED Power Saving Mode
Network
Solid Green
Connected to an LTE network
Off
Solid Amber
Connected to a 3G or 2G network
Off
Flashing Green
Connecting to the network
Flashing Red
No network available
Flashing Red/
Amber
Network Operator Switching is enabled, but the gateway is unable to locate
the required firmware. For more information, refer to the ALEOS Software
Configuration User Guide (Admin chapter)
Activity
Flashing Green
Traffic is being transmitted or received over the WAN interface
Flashing Red
Traffic is being transmitted or received over the serial port. This behavior only
appears if the RV50 is configured to display it. For more information, refer to the
ALEOS Software Configuration Guide (Serial chapter)
Flashing Amber
Traffic is being transmitted or received over both the WAN interface and the
serial port. This behavior only appears if the RV50 is configured to display it.
Refer to the ALEOS Software Configuration Guide (Serial chapter)
All
Green LED
Chase
Radio module reconfiguration/firmware update or Network Operator Switching
is in progress
Amber LED
Chase
ALEOS software update is in progress
4.
Contact the cell service provider to ensure service is available.
5.
Contact Daktronics at 1-800-325-8766 for assistance troubleshooting display hardware or software.
Control Software Configuration and Display Network Configuration
Click the article links below or go to
www.daktronics.com
and enter the DD number in the search box
at the top-right of the home page for information specific to Control Software configuration or Display
network configuration.
•
To configure Venus
®
1500 Version 4 software, reference
How to configure a display in Venus 1500
using a CDMA modem (DD2325961)
.
• For information regarding Galaxy
®
display network configuration of the display controller follow
How
do I change the static IP address on a Galaxy display? (DD1980638)
.
Note:
To set AF series Galaxy
®
or GalaxyPro
®
displays to factory default IP schemes, follow
What is
the default IP address on a Galaxy or GalaxyPro display? (DD2430017)
.
• For information regarding GalaxyPro
®
display network configuration follow
How do I change the IP
address settings on a GalaxyPro
®
message center? (DD1996041)
.
Note:
These displays can be set to DHCP when utilizing a 4G modem.
