Daktronics BA-2000 Series, Display Manual

Page: 24 / 112

18 Electrical Installation
1. Look for a warning label similar to Figure 14 to
locate the appropriate front or rear access panel to
the driver enclosure.
2. Loosen the screws or latches to open the access
panel. Front panels are hinged and swing open.
Rear access panels can be lifted up and out over the
screws through keyholes.
3. Loosen the screws securing the metal cover of the driver enclosure, and lift the cover
up and out over the screws through keyholes to expose the driver components.
4. Connect the appropriate wires coming through the rear of the scoreboard to the
power terminal block, as shown in
Figure 15 .
5. Reattach the metal driver enclosure cover and secure the access panel.
Note: If a power receptacle is needed to operate the control console at the scoreboard for
troubleshooting, Daktronics recommends that an installation electrician provides a 120 V
outlet close to the disconnect box specifically for this purpose.
Figure 14: Power Warning Label
Figure 15: Driver Enclosure & Power Terminal Block