DD2077845 Rev 2
18 May 2016
All Sport 5000 Series Console Quick Start Guide
2 of 4
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/allsportsupport
Start Up
1.
Plug power cord into standard wall outlet or battery pack.
2.
Connect all signal cables to their appropriate jacks, if they are not
already connected. Wireless radio systems may not require these signal
connections. Refer to scoreboard installation manuals and/or site-specific
System Riser Diagrams for more information.
3.
Slide a sport insert into the sleeve over the keypad (see Page 3).
4.
Flip the
POWER
switch on rear of console to the
ON
position.
5.
The console will perform a self-test when it is powered on. During the
self-test, a message will display the version of the standard software
loaded in the console:
6.
When the self-test completes, a prompt displays the code number for the
last game played. This is useful when power to the console is lost during
a game.
○
Press
<YES>
to resume the last game stored in memory.
The console is now ready for game operation.
○
Press
<NO>
to start a new game or change sports. The console will
prompt for a new code number as shown below.
Use the number keypad to enter the new sport code, and then press
<ENTER>
. Sport codes can be found on the sport-specific insert and in
the Operations Manual. Refer also to Page 3.
AS-5000 VX.X.X
ED-11544
V = version and revision number
ED = standard software number
PREV CODE NNNN
RESUME GAME?
NNNN = last code selected
SELECT CODE
CODE NNNN
NNNN = current code entered
Radio Settings
If the radio option is installed, the console will also prompt for the radio
settings after changing the sport code. Press
<ENTER>
to accept the current
settings or press
<CLEAR>
to modify them.
The radio settings in the console (transmitter) must match the scoreboard
(receiver) radio. By default, both are set to
Broadcast Group 1, Channel 01
.
To determine the settings of a scoreboard, first power it down and shut off any
radio-equipped consoles in the area. Next, power the scoreboard back up and
watch for the radio settings. The settings will appear as “
bX CY
” where
X
is the
current broadcast group and
Y
is the current channel:
The settings are typically displayed in the clock digits or Home and Guest
score digits, depending on the scoreboard model.
Refer to
Section 2.4
of the Operations Manual for more information about
radio settings.
RADIO SETTINGS
BCAST X CHAN YY
X = current broadcast group
YY = current radio channel
Radio Settings in Clock Digits
daktronics
PERIOD
GUEST
HOME