Daktronics 65 Series, Installation Manual

Page: 17 / 29

Webcam Mounting
13
6 Webcam Mounting
The display ships with a fixed length webcam arm unless the optional retractable
webcam arm is requested. For additional mounting or assembly details, refer to the arm-
specific drawings located in Section A: Reference Drawings (p�23) .
Mount the Webcam to the Arm
1� Locate the webcam assembly inside the
display behind a door labeled Webcam
Located Here.
2� Identify all webcam mounting components.
3� Using the wire shipped in the webcam arm,
pull the Ethernet and ground cables through
the webcam arm.
4� Verify there is enough excess cable to allow
the webcam arm to pivot if needed.
5� Slide the webcam arm between the top
and bottom tube saddles until the webcam
assembly is two inches from the end of the
webcam arm. Refer to Figure 22 .
6� Tighten all four saddle bolts.
7� If necessary, turn the webcam assembly until it will face the display when mounted.
Standard 10-Foot Fixed Webcam Arm Installation
Standard 10-foot fixed webcam arms are used on
display less than or equal to 10 modules high and
less than or equal to 33 modules wide.
1� The webcam arm ships with all hardware
and arm components. Remove the
5
/
8
″ nuts
and washers from the arm assembly before
installing the webcam arm. Refer to Figure 23 .
2� Before hanging the display, slide both
mounting channels with the bolts into the
horizontal mounting channel.
3� Align and slide the webcam mounting
assembly over the mounting channel assembly bolts.
4� Place a washer on each
5
/
8
″ bolt.
5� Attach the
5
/
8
″ nuts to the bolts to secure the mounting assembly to the display.
Tighten hardware to 75 ft-lb.
6� Using fish tape, feed the webcam cables through the webcam arm tube.
7� Connect the webcam cable to the Primary Webcam connection on the back of the
display.
8� Secure the green webcam grounding wire to the groundling lug near either end of
the display back.
9� Neatly secure excess power grounding with cable ties.
Saddle Bolt
Top Tube
Saddle
Top Tube
Saddle
Figure 22: Mobotix Webcam Mounting
Mounting
Channel
Bolt
Nut
Washer
Figure 23: Fixed Webcam Arm Mounting