Daktronics 65 P2210, Service Manual

Page: 14 / 31

Access Internal Components
10
4 Access Internal Components
Rear Access
DB-65 series digital billboards have lift-off doors that are
secured with a tab in the top-left corner. Refer to Figure 9 .
1� Place fingers in slot located at the top-left corner of
the door.
2� While pulling up on the handle in the center of the
door, pull the top-left corner of the door outward so it
clears the tab located on the door. Refer to Figure 9 .
3� Lift the door upward to disengage its tabs from the
slots on the display’s backsheet. Refer to Figure 10 .
4� Lower door until its top lip is free of the backsheet.
To completely move the door out of the way, disconnect
the lanyard connected to the door.
Front Access
Remove modules from the display front to gain access
to the cabinet’s interior. Refer to the steps in Remove a
Module From the Display Face (Front Access) (p�11) .
Figure 9: Rear Access Door Slot
Figure 10: Removing Door