Daktronics 6000 Series, Installation Manual, Page: 20 / 31

Webcam Mounting
16
12� Tighten all mounting and webcam assembly bolts.
13� Connect the webcam cable to the Primary Webcam
connection below the power entrance box on the
back of the display.
14� Secure the green webcam grounding wire to the
grounding lug near the end of the display back. Refer
to Figure 25 .
15� Neatly secure excess grounding wire with cable ties.
16� Ensure all webcam and webcam mounting bolts are
secure prior to hanging the display.
17� After hanging the display, connecting display power,
and starting the display, call Daktronics NOC and
have a technician verify they can detect the video
server. If the video server is not detected, ensure the
power and signal cables are securely attached to
the camera and display. Make sure the video server
has power and is connected with Cat-5e cable to the
network switch on the router.
18� Work with the NOC to ensure the camera is aligned properly. If adjustment is
required, pivot the arm to the display face and adjust as needed.
Optional Retracting the Webcam Arm
1� To retract the webcam arm, remove the two
short bolts from the top of the elbow assembly
and loosen the third bolt that is located in the
slot for rotation.
Note: Do not remove the long bolts.
2� Use the handle to carefully pivot the webcam
arm to the front catwalk.
Note: Verify that power and signal cables
are not pinched when pivoting the
webcam arm.
3� Return the webcam arm to the original
position when done servicing the webcam
arm.
4� Replace and tighten the three short bolts.
5� Work with Daktronics NOC to verify the
webcam is focused and functioning properly.
Figure 25: Webcam Ground Lug
Nut (x2)
Bolting Template
Bolt
Mounting
Channel
Remove Bolts
to Retract
Webcam Arm
Figure 26: Pivoting Webcam Arm Base