page 3
MAN#650244:A
SPEED
Speed gauge menu
UNIT
Select unit for speed
Toggle between MPH and KPH (select unit to use for calibration)
AUTO
Auto calibrate speed to a marked mile or kilometer
Pulls up all values
on speed and speed pulses in odometer
Press Right switch to finish cal and save value
ADJUST
Adjust speed cal while driving
ADJUST
Each press of left switch toggles direction of adjustment, right switch to save and exit
SRV MI
(
SRV KM
)
Sets value of service odometer set when service odometer is reset
OFF
(
OFF
)
Turns off the count down service odometer (default)
500
(
800
)
Sets service to 500 mi or 800 km when resetting service odometer.
….
Service point can be set in 500 mi (800km) increments.
7500
(
12000
)
Sets service to 7500 mi or 12000 km when resetting service odometer.
MAIN
Returns to info menu
TACH
Tachometer gauge menu
update
Sets update rate for tachometer readout screen
SLOW
tach updates at slowest rate (default)
MEDIUM
FAST
fastest update on tach
WARN
Sets RPM warning point (default 5500 RPM)
W 2250
Minimum warning point of 2250 RPM
….
Warning point can be set in 250 RPM increments
W 9750
Maximum warning point of 9750 RPM
SRV HR
Sets service hour value used when resetting count down service hour meter
OFF
Service hour meter disabled (default)
10
Minimum service hour set point
…
Service hour reset point can be set in 10 hr increments
310
Maximum service hour set point
MAIN
Returns to info menu
GAUGES
Gauge option menu
VLT HI
Set high voltage warning point (default 15.4V)
VLT LO
Set low voltage warning point (default 11.1 V)
OIL LO
Set low oil pressure warning point (default 9 PSI)
WTR HI
Set high water temp warning point and set temperature unit (default 251F)
DEG F
(
DEG C
)
Select temp unit, press left switch to change, right switch to save
WTR HI
Select high warning, left switch to change, right switch to save
MAIN
Returns to info menu
OPTION
Option menu
DIM LV
Adjust dimming point on gauge
OFF
Dimming function is off
LVL 1
Gauge will dim when light on gauge face is very low (default)
…
7 selectable dimming levels
LVL 7
Gauge will dim early when more light is on gauge face
DM OUT
Enables/disables dim output for other gauges
ON
Dim output will be high when gauge is dimming
OFF
Dim output will be disabled (default)
WN OUT
Selects which gauges provide a warn out signal on warn out wire (default all on)
WN OUT
Gauges that provide signal out are lit up, left switch to change, right switch to save
NO WRN
Warn output wire is disabled
CLOCK±
Adjust clock speed for accuracy
-7 SEC
Subtract 7 seconds from clock every 24 hrs
…
0 SEC
No adjustment to factory clock speed (default)
…
+7 SEC
Add seven seconds to clock every 24 hrs
St odo
Allows presetting of odometer value on initial install (not available after 10 miles / 16km)
Set hr
Allows presetting of hour meter value on initial install (not available after 1.0 hrs)
MAIN
Returns to info menu
DONE
Leaves setup menu if selected