REM-4D
REMOTE CONTROL
DOOR LATCH OPENER SYSTEM
INTRODUCTION
Thank you for purchasing the REM-4D Remote Control Door Latch Opener
System from Dakota Digital, Inc. This, along with many other products that Dakota
Digital, Inc. has to offer, represents the latest in electronics technology for the street rod,
classic car and truck, and any custom vehicle.
The REM-4D Remote Control Door Latch Opener system comes complete with
receiver, two key chain transmitters, wiring harness, emergency release switch, and
three door opener motors. It is installed to remotely release the driver's and
passenger's door independently along with a third channel to release a trunk, rear door,
or whatever. A safety feature disables the system when the ignition is on to avoid
accidental door opening during vehicle operation. Two internal door release buttons
can be wired into the system for removal of inside door handles as well. An emergency
release switch can be concealed on the underside of the vehicle should the door ever
be closed with the motor running and you on the outside. Pressing this button will allow
reentry to the vehicle even though the remote control system is disabled.
INSTALLATION
While installation of the REM-4D is very straightforward, paying a little attention
here and planning out how the system will fit into your specific vehicle will save some
time in the long run. First, determine the best mounting method for the door motors
within the doors. The pull (or push) on the original door latch or newer bear claw latch
should be as straight as possible. Securely mount the motor and route the connecting
rod as pertains to your specific situation.
The receiver should be mounted under the dash up on the fire wall for best
access to wiring. The kick panel is also another good location for the receiver.
Connect the REM-4D system as is shown in the wiring diagram. While the wiring
diagram is self explanatory, there are several key areas to pay particular attention to.
First, the 12 volt source should be able to supply up to 10 amps (needed if two or three
1
Summary of Contents for REM-4D
Page 3: ...4 3...
