MAN#650125 C
PGR-1000 SERIES
Programmable Gear Readout
See back page for alternative wiring for bikes w/ECM tach output
Display readout:
‘n’
-transmission in neutral
‘-‘
-no speed or rpm signal. (key on with engine off)
‘0’
-engine is running, but no speed signal. (key on with engine on)
‘E’
-speed signal is present, but no rpm signal.
‘1’ – ‘7 ’
-current transmission gear.
‘C’
-settings cleared and waiting to learn gear pattern.
Programming:
When the display shows a flashing ‘C’ or ‘n’ it is ready to start learning the gear pattern.
(If your initial stretch of road will not allow you to reach top gear, please try to avoid shifting
into 3
rd
gear until you have a long stretch of road in front of you.)
After you start the engine you should se
e a flashing ‘0’.
Once you start driving this will change to a flashing ‘1’.
Drive at a constant speed in 1
st
gear for 20-25 seconds. Once the display quits flashing,
shift to 2
nd
.
Drive at a constant speed in 2
nd
gear for 20-25 seconds. Once the display quits flashing,
shift to 3
rd
.
Repeat these steps until you have programmed all of the gears in order. Once you stop or
shift into neutral the settings will all be saved and the readout will begin normal operation.
