MAN#650129A
2
Features
The PAC-3200 is designed to control two linear motors at the same time. It is
intended to be used to lift heavier trunk lids and toppers / Tonneau covers that require more
than one motor. The PAC-3200 has many convenient features which include:
Three user programmable heights
Stylish, lighted push button control
Remote, ground activated, input lines to control the system with a remote system
Safety auto reverse
Auto move to position when the vehicle is turned on / off
Single motor adjustment
Wiring
BLACK
-
Connect to a main ground location
RED
-
Connect to fused constant 12 volt power
YELLOW
-
Connect to switched 12 volt power
(An accessory terminal will work for this)
PURPLE
-
Optional remote ground trigger for preset 3
PINK
-
Optional remote ground trigger for preset 1
BROWN
-
Optional remote ground trigger for preset 2
WHITE w/ BLACK -
Optional emergency switch (ground for manual down)
WHITE w/ RED
-
Optional emergency switch (ground for manual up)
PRESET BUTTONS -
To mating 4 pin connector
Mounting
The linear actuators should be mounted following the instructions supplied with them.
It is very important to mount the motors correctly or damage to the vehicle could result.
Remember that the motors should be mounted so they are completely closed when the
trunk/cover being lifted is shut all the way. Also insure that the motors can not rise too far
and cause damage.
The controller should be mounted inside the vehicle and all wires routed through the
vehicle to appropriate connections or motors.
The controller should NOT be mounted in
the trunk area or under the cover being lifted for emergency service access. It is also
recommended that manual up/down switches be installed in case of emergency.
The preset buttons require an oval hole to be cut for mounting, keeping in mind the
buttons can be mounted h
orizontal or vertical. Drill two ½” holes 1.8” apart on center, then
cut from hole to hole.
1/2" Hole
Cut dotted lines
Once the hole is cut, insert the button panel from the front. From the back, slide the L-
clamps over the studs and secure with the supplied lock washers and nuts.