MAN# 650013;B
Wiring:
BLACK -
connect to a good ground point in the vehicle.
RED
-
connect to switched 12 volt power point.
(An accessory terminal will work for this.)
ORANGE
-
connect to a constant 12 volt power point.
(This will keep the correct time.)
BLUE
-
connect to the tail light circuit.
Mounting:
The CLK-57C clock is designed to fit into the stock clock location. It should be inserted into the opening
from the front and the U-clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the
gauge is secure.
Troubleshooting guide.
Problem
Possible cause
Solution
Clock will not light up
Red wire does not have
Connect to a location that has power
power.
when the key is on.
Orange wire does not have
Connect to a location that has power
power.
all of the time.
Black wire is not getting
Connect ground to a different location.
a good ground.
Power is reversed.
Connect black to negative ground, red and
orange to +12V power.
Clock is damaged.
Return clock for repair. (see instructions)
Clock will not turn off when
The red and orange wires
Connect the red to switched power, the
the key is off.
are reversed.
orange to constant power.
Clock lights up, but does
Loose connection on orange
Reconnect orange wire.
not read correctly.
power wire.
Poor ground connection.
Move ground to different location
Time is not set.
Set time. (see instructions)
Clock is damaged.
Return clock for repair. (see instructions)
Clock will not keep time.
Orange wire does not have
Connect to a location that has power when
constant power.
the key is on or off.
Loose connection on orange
Reconnect orange wire.
power wire.
Poor ground connection.
Move ground to different location
Clock will not dim.
Blue wire is not connected
Check wiring connections.
correctly.
Clock remains dim at all
Blue wire is getting power
Connect blue wire to location that only
times.
all of the time.
has power when the headlights are on.
Battery is very low.
Recharge or replace vehicle battery.
Clock is damaged.
Return clock for repair. (contact factory)
Technical specifications
Minimum operating voltage
-
7 volts
Maximum operating voltage
-
18 volts
(operating at or near maximum rating for an extended time can damage unit)
Clock accuracy
-
2 minute per month
Typical current draw (@ 13.8V) -
0.13 A
Standby current draw (key off) -
0.002 A
