page
1
MAN#650252
AI-250
MCL-5000 Series Installation Kit for
American Iron Horse drag bar mount
Gauge installation:
1.
Remove the two screws from the top of the original gauge that hold it to the bars and remove the gauge.
Keep these screws to mount the brackets from this kit to the bars.
2.
Disconnect the original gauge harness from the bike at the two connectors located close to the frame under
the front side of the tank.
3.
Remove the stock harness from the bike noting where the harness is routed.
4.
Route the wiring harness from this kit back into the routing location of the original harness.
5.
Install the mounting brackets following the instructions below for either below or above bar mount.
NOTE: The views are looking from the front of the bike.
Kit includes:
(1) Wiring harness
(1) Top mount bracket
(1) Bottom mount bracket
(2) 10-
32 X 3/8” socket head screws
(2) 10-32 X 1/2" socket head screws
(4) Cable ties
(1) Installation kit instruction manual
BELOW BAR MOUNT
ABOVE BAR MOUNT
Locate all the mounting hardware.
Locate all the mounting hardware.
Using the original gauge mounting
screws, attach the top mounting
bracket to the bars.
Using the original gauge mounting
screws, attach the top mounting
bracket to the bars.
