2
MAN # 650466
INSTALLATION:
Remove the outer fairing and the factory Air Temp gauge. This will vary by model; please follow the service manual to
expose the wiring and gauges. Don’t be alarmed by the amount of wires behind the fairing, this is a direct plug in kit and
these detailed instructions will guide you through installation.
With the Air Temp gauge removed; slide the push button harness through the fairing at the top opening of the
mounting basket and bring the factory 3-pin connector through the fairing at the bottom opening of the mounting
basket. The top and bottom openings are shown with arrows in the picture.
Connect the factory 3-pin connector and the
switch harness to the LCD compass gauge.
With the switch harness connector at the top, slide the gauge into the fairing with the two studs sliding through the holes
of the stock mounting basket. Use the provided nuts to secure the gauge to the mounting basket. One extra nut is
provided in case one is lost.
Use the provided zip ties to secure the switch to your desired location. You
shouldn’t need to access the switch after
going through the operation and setup of the LCD compass, so you can secure the switch up inside the fairing or you can
secure the switch making it accessible under the fairing after reassembly if you want to change the backlighting or
settings later on.
